THOR Jayco NORTH POINT 2021, Owner'S Manual

Page: 149 / 209

147
Section 8: Plumbing System
Draining the Aqua Go Water Heater
The Aqua Go water heater does not have a conventional drain plug. Instead it includes a
“drain chute”.
 Water heater power should be OFF, water pump OFF, and fixtures open to relieve
pressure on the plumbing system. DO NOT DRAIN THE WATER HEATER
IF IT IS HOT OR UNDER PRESSURE!
 Open the water heater exterior door to the “service” position hanging by the straps.
 Open the drain chute by pushing UP on the black button above the yellow label on
the left side of the water heater (photo A ). This releases the drain chute.
 Push the chute all the way open which will dump water out of the water heater
away from the side of your RV. Water heater contains approximately 1.5 liters of
water.
 Drain all the water out of the water heater.
 The water inlet filter is located inside the drain chute (photo B ). The filter will pull
out of the opening in the drain chute. Rinse it with clean water, inspect O-rings
for cracks.
 To close the drain chute, push it up until it latches back into place. You will hear
an audible “click” when the chute engages.
NOTE: If the inlet filter is difficult to re-install, use a small amount of soap
on the O-rings. NEVER USE GREASE as the O-rings are not resistant to
grease.
Draining the Aqua Go Water Heater