If need replace the compressor, remove the rear cover, and cabinet, locate the compressor.
Unplug the lines and taken out the earth line, add low side access valve, open the Process/Suction, evacuate
refrigerant, take out the compressor, replace a new one, joint together, then recover refrigerant, weigh in the
nameplate charge.
Reverse the above step to reassemble.
2. Replace the fan motor and fan blade.
Remove the front panel, rear and cabinet.
locate the fan motor, unplug the lines connecting with the fan motor, loosen the screws of holding fan motor
bracket.
Replace a new one, If only need replace the fan blade, loosen the screws holding the fan blade, taken out the
damaged, replace a new one.
Reverse the above step to reassemble.
3. Replace the hot gas valve, drier and evaporator.
Remove the rear cover.
Locate the drier and hot gas valve, add low side access valve, recover refrigerant, replace the drier and hot gas
valve, evacuate and weigh in the nameplate charge.
Reverse the above step to reassemble.
If need replace the evaporator.
Remove the rear, locate the evaporator, add low side access valve, open the process/suction , weld open the two
welds, replace a new one. Recover refrigerant, evacuate and weigh in the nameplate charge.
Reverse the above step to reassemble.
4.Replace the LED Light.
Remove the screw fixed on the LED Light.
Reconnect the connector. And remove the damaged LED Light.
Connect the new LED Light, then fixed the screw.
18
