Adjustment and Replacement
Replace Controller, fuse and the sensor of temperature
Remove the rear cover, front panel,
Locate the Electronic controller,
Pull out the sensors of temperature (one at the evaporator, another at the condenser).
loosen the screws of rooting the Electronic controller, replace a new one. Reverse the above step to replace.
If you need replace the fuse, open the front panel of the control box, you will find the figure.
According the figure, take out the fuse, replace a new one.
Reverse the above step to reassemble.
If you need replace the sensors of temperature, pull out the sensor of temperature, open the panel of the controller
box, pull out the other side, replace a new one. Reverse the above step to reassemble.
Replace the water system components
Please see the water system drawing. The water leakage should be checked after this kind of operation
1. Replace the water pump
Disconnect electrical power.
Remove the rear cover.
Unplug the lines connector with the water pump, the water outlet tube of pump and the water inlet tube of pump.
Loosen the screws, replace a new one.
Reverse the above step to reassemble.
Replace the cooling system components
Replace the condensing components, See Figure “cooling system”
1.Replace the compressor and the compressor kit
(includes relay, thermal protect).
If only need replace the compressor kit, remove the rear, locate the compressor, take the clip, open the cover,
replace the wrong,
Reverse the above step to reassemble.
17
Before replace the water system components, it will be necessary
to drain the system of water.
ELECTRICAL SHOCK HAZARD
Disconnect Electrical Power Before
Beginning Removal of Parts
