Jan 9th 2019
www.thonk.co.uk
11
God’s Box – Loose Fruit
Eurorack DIY Kit
Instructions
Version 1.1
25.
Next place but DO NOT SOLDER
the pots, jacks and switch.
Screw just one of the hex nuts
onto the switch - do not use the
switch washer.
Make sure the taller black trimmer
is correctly placed in the position
labelled WSHAPE2 as pictured.
NOTE:
Before soldering the LEDs
it’s recommended to use masking
tape to hold them to the front
panel.
Place the tall black pot where the
PCB is labelled WSHAPE2
26.
We recommend having the domed
section of the LED just poking out
from the panel for the best looking
finish.
Now carefully place the front panel
and
secure
some
of
the
components with their nuts to hold
the panel in place.
With the LEDS held in position with
masking tape you can then solder
in all the front panel components.
NOTE!
Do not use regular tape as it will
leave a sticky residue on the panel –
only use masking or non-stick tape to
hold the LEDS in place.
27.
Now connect the two PCBs
together - securing the two hex
spacers with screws. Then you can
screw on the rest of the nuts onto
the front panel components and
place the three knobs onto the
pots.
SHORT
TALL
SHORT
SWITCH NUT
