ConnECTIons
P5
English
2.5Installingthebatteries
Fig. 4
Remove the battery cover from the remote control and put 2x AAA size batteries inside
the compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.
1. Open the cover
2. Install batteries
3. Close the cover
noTE:
The batteries should not be recharged, disassembled, electrically short-circuited, be mixed
or used with other types of batteries. If rechargeable accumulators instead of batteries
are going to be used, we recommend using (e.g. NiMH) types with low self-discharge to
ensure long time operation of remote control.
2.6usingtheremotecontrol
Fig. 5
To use the remote control, point it towards the front of the digital receiver. The remote control
has a range of up to 7 metres from the receiver at an angle of up to 60 degrees.
The remote control will not operate if its path is blocked.
3.0ConnECTIons
3.1basicconnectionwithsCarTcable
Fig. 6
3.2Connectingtosatellitedish
Connecting a fixed satellite dish to your receiver
Fig. 7
Connecting multiple fixed dishes to your receiver using a DiSEqC 1.0 switch
Fig. 8
3.3Connectingusbdevicetodownloadsoftwareand
userdata
Fig. 9
3.4ConnectingandusingtheIrextender
The included IR extender allows you to place the receiver out of sight (e.g. in a closed cabinet)
while still being able to control it. Plug the IR extender into the IR connector on the back of the
receiver. Locate the extender on a position giving it direct sight to the remote control. Once a
suitable location is found, remove the protecting foil from the adhesive tape on the back of the
extender and fix it by slightly pressing it down on the surface it should be placed on.
4.0sTarTInguP
Ensure your satellite signal is of good quality. It is recommended that you perform the first time
installation following the Installation Wizard step by step. It will help you to easily achieve system
configuration and channel installation.