THOMSON TM-SAL04DA, Instruction Manual, Page: 16 / 22

Put the jug onto the warmer Start brewing
9 10
● Put the jug with lid onto the warmer plate.
● If the jug is not put correctly, the drip-stop function
will not work, which would cause the basket to overflow.
● Put the jug onto the machine and its mouth towards
the machine. The coffee temperature will be higher
this way.
Chose desired amount and flavour
●Set the number of cups, and the machine will grind the amount of beans that
correspond to the selected number of cups. The indicator lights come in red
and green. 3/5/7/9 correspond to red and 2/4/6/8 correspond to green.
●Please ensure that the number of cups you have selected is consistent with the
amount of water in the container. Please remember that the coffee machine will use
up all the water in the container.
●
Adjust the amount of grinding of the beans, i.e. the increase or decrease
that correspond to the standard amount of beans to meet your requirements for
the coffee flavour (strong or light).
● Long-press 2s on/off
button,light on.
● Light-press,choose
“bean”.
● Light-press,choose
cups.
● Light-press,adjust
coffee strength
保温
取消
粉
豆
电源
M
模式 杯量 浓淡
浓2
浓1
标准
淡1
淡2
The accurate ratio of water amount to coffee beans would make for
better coffee. You can make better coffee by following the method below.
●Weigh the amount of beans enough for a one-time brew and
set “+2” or one more cup of grinding correspondingly to let the grinder
finish grinding all the beans at once.
● Measure the correct amount of water.
●Press 2s to start grinding. When the “Grind” indicator light is on, the machine
will grind the desired amount of coffee beans.
● Display runs and brewing starts.
● Please check the filter basket if this signal
is displayed.
● When the “Clean ” light is on, the machine cannot
be started. Press and hold the key until the indicator
light flashes to prompt you to wash the filter cup.
● If you need to stop the brewing, press the key for 2s
until the “ Clean/Maintenance” light is on.
●Washing the filer cup Take the filter cup out
for more than 4s until the “Clean/Maintenance”
light goes off. (Please wash the filter cup
promptly after use each time. Do not leave
wet coffee residue in the cup overnight. This
would reduce the blockage of the coffee powder
chute to retain the coffee’s freshness and aroma.)
●When the “Keep Warm” indicator light flashes, the timer for keeping warm
will start and the time will be displayed.
●Take the jug out and pour the coffee into a cup.
(Note: When the brewing is done, a few drops of coffee would drip from
the filter cup for a few seconds.)
●At the end of the keeping warm, the “Clean/Maintenance ” light comes on. The display
will go off if there is no operation within 3 seconds (the “Clean/Maintenance” light
remains on).
工作状态指示
清洁/保养
保温
冲煮
研磨-Flash
Grinding Brewing Keep warm Remind to clean Finish clean
启动
暂停 启动
暂停 启动
暂停 启动
暂停 启动
暂停
清洁/保养 清洁/保养 清洁/保养 清洁/保养
保温 保温-Flash 保温 保温
冲煮-Flash 冲煮 冲煮 冲煮
研磨 研磨 研磨 研磨
Light on Light off
light on light on
light on
light on
Flash