THOMSON GRASS VALLEY Profile XP PVS3000, Installation Manual

Page: 25 / 48

23 February 2004 PVS3000 & PVS 3500 Installation Guide
25
Set up PFR500 or PFR600 network
settings
This procedure explains how to modify factory default PFR500 or PFR600 network
and SNMP settings for monitoring with NetCentral Lite or NetCentral Manager. This
step is not required for PFC500 RAID storage systems.
NOTE: Disregard this step if you are connecting one Profile XP Platform and
PFC500 RAID storage system to a network using factory default network settings.
Proceed to “Start NetCentral Lite monitoring software” on page 33.
PFR500 or PFR600 network is set up using a console program accessed through the
serial port on the RAID Controller and Hyperterminal, running on the Profile XP
system. Both RAID controllers must be configured if the optional RAID Controller B
is installed. Refer to the Profile XP Service Manual for information on using
NetCentral Lite.
Modifying network and SNMP settings on RAID Controller A
This procedure assumes the PFR500 or PFR600 is cabled and powered-up as shown
on pages 11 and 12 or pages 13 and 14.
To configure PFR500 or PFR600 network and SNMP settings:
1. Start a Hyperterminal session using the following steps:
a. Click
Start | Programs | Accessories | Hyperterminal | HyperTerminal
.
b. In the Connection Description dialog box, type
pfr
, then click
OK
.
c. In the Connect To dialog box, click
OK
.
d. In the Com1 Properties dialog box, click
Restore Defaults
, then click
OK
. (9600,
8 bits, parity none, stop bit 1, flow control none) A flashing cursor appears in the
terminal window.
2. Use the instructions in the following table to modify RAID controller settings.
1
5
1
6