THOMSON GRASS VALLEY Profile XP PVS3000, Installation Manual

Page: 14 / 48

14 Set up RAID Storage: PFR 600/E (Local storage only) 23 February 2004
IMPORTANT: If you are installing your PVS3000 as part of an Open SAN, do not perform
this RAID storage setup. Instead, follow the instructions in the
Open SAN Instruction
Manual
for setting up RAID storage.
Power Cord
(115V/230V)
Power Cord
(115V/230V)
Install ethernet cabling and switch or hub as shown.
5
3
Install serial cabling as shown.
4
PFR 600
RAID
Chassis
PFR 600E*
Expansion
Chassis
PFR 600E*
Expansion
Chassis
Media Platform
Ethernet Hub or Switch
Power-up Verification
Rear panel "7 Segment LED" displays the chassis address as
set in step .
All disk drive LEDs are green after approximately 3 minutes.
Refer to the PFR 600 Instruction Manual if there is a problem.
Disk Drive LEDs
7 Segment
LEDs
PFR 600
RAID
Chassis
PFR 600E*
Expansion
Chassis
PFR 600E*
Expansion
Chassis
Caution: See serial cabling detail below.
Media Platform
After RAID Controller A is configured,
the standard serial cable will be moved
to this connector to configure RAID
Controller B, if installed.
Maximum of 4 Expansion Chassis
* If Installed
This cable used for PFR 600s
with optional RAID Controller B.
This cable used for
PFR 600 chassis with optional
RAID Controller B.
Standard
Serial Cable
Serial Cabling Detail
(Applies to primary and
redundant cabling)
Always plug the end
connector of dasiy
chain cable into last
expansion chassis.
Always plug the first connector
into the PFR 600 RAID Controller.
Leave
unconnected
Connect power cords, and turn on power as shown.
You must power-up the PFR
600E Expansion
chassis prior to, or at the same time as the PFR 600
RAID Controller chassis. Verify power-up as shown.
1
3
d
Set up RAID Storage: PFR600/E
(Local storage only)
Use this diagram to connect Ethernet and serial interface cabling required for monitoring the
PFR 600/E with NetCentral Lite or NetCentral Manager and microcode updates.