thomann STAIRVILLE LED PAR56 24x3W RGB MKII, User Manual

Page: 29 / 48

To configure the device as slave, press one of the arrow buttons repeatedly until the display
shows ‘SLAVE’ . Press [OK] to confirm the selection. The device is now configured as slave and
follows the settings of the master device to which it is connected. Make sure that on all devices
configured as Slave the DMX address is set to 1.
To return to the parent menu without making changes, press
[M] .
This setting is only relevant if the device is not controlled via DMX.
Press [M] . Press one of the arrow buttons repeatedly until the display shows ‘CHAN’ . Press [OK] .
Now you can select one of the preprogrammed automatic shows. Use the arrow buttons to
select a value for the progress speed between 0 and 255. (Display shows ‘C000’ … ‘C255’ ).
The auto show can only be activated on the master device.
This setting is only relevant if the device is not controlled via DMX. The device can operate in
stand-alone mode or control connected devices of the same type, that must be configured as
slaves. When the display shows the desired value, press [OK] to confirm the selection and then
[M] to return to the parent menu. To return to the parent menu without making changes, press
[M] .
Operating mode ‘Slave’
Operating mode ‘Show 1’
Operating
LED PAR56 24×3W RGB MKII LED PAR64 36×3W RGB MKII
29