1.
Hold
[PROGRAM
½
RECORD]
down for three seconds to switch to Program/
Record mode.
2.
Use
[CHASE]
to select the required sequence. To do this, switch between the
two memory banks using the toggle button if need be.
ð
The associated CHASE LED lights up.
3.
Use
[FIXTURE]
to select the channel you wish to program.
4.
Use the Flash controllers 1 to 8 to set the required values.
5.
Press
[PROGRAM
½
RECORD]
to save the new values.
ð
All of the device LEDs flash briefly and the following values appear on the
display:
6.
Repeat steps 2 to 5 to add further program steps.
7.
Hold
[PROGRAM
½
RECORD]
down for three seconds to exit recording mode.
1.
Hold
[PROGRAM
½
RECORD]
down for three seconds to switch to Program/
Record mode.
2.
Use
[CHASE]
to select the sequence you wish to expand. To do this, switch
between the two memory banks using the toggle button if need be.
3.
Briefly press
[MIDI
½
IN SET]
.
ð
The associated display LED flashes.
4.
If necessary, use and to select the step number under which you wish to
insert the program step.
5.
Use
[FIXTURE]
to select the channel you wish to program.
6.
Use the Flash controllers 1 to 8 to set the required values.
7.
Press
[PROGRAM
½
RECORD]
to save the new values.
ð
All display LEDs flash three times.
8.
Repeat steps 4 to 7 to add further program steps. The 16 memory locations can
be assigned a total of 250 program steps.
9.
Hold
[PROGRAM
½
RECORD]
down for three seconds to exit recording mode.
Programming chaser sequences
Inserting a program step
Operating
DMX controller
16
