thomann expolite tourled pro, User Manual

Page: 3 / 12

1.1 PRODUCT INTRODUCTION
This product is designed for indoor or outdoor use. Suitable applications
include wash or effect lighting for architectural, stage,theatre or road show
applications. Direct input of DMX512 signal allows the units to be controlled
from any DMX512 controller. This product can be operated as a single unit or
in multiple units for large applications.
1.2 PRODUCT FEATURES
LED FIXTURE
1 PRODUCT(GENERAL) 1
* IP67 protection rating
* RGBW Dimmer 0-100%
* Strobe
* Built-in automatic programs
* Upload custom parameters to slave fixtures
* LED display
* Display control 'lock-out'
* Direct DMX512 input
* Independent ID address
* Different white colors setting
* 'Over-heat' protection
1
PRODUCT (GENERAL)
No display
SITUATION CAUSE ACTION
5.1 TROUBLE SHOOTING
1) No power input
2) Power connection error
3) Display damaged
4) Display board IC error or power input
connection error or two board connection
error
5) Contrast decay
1) Check power supply
2) Check power connection
3) Replace display
4) Check the IC and all the connections
5) Adjust the LCD contrast
1) Display IC reverse install
2) Display IC damaged
1) Check Display IC installation and quality
LED MODULE
on, but no control
from display
Display normal,
but no response
from buttons
1) Buttons damaged
2) Display IC damaged 1 ) R e p l a c e b u t t o n s
2) Replace Display IC
1) Signal Cable error
2) Signal conncetion error
3) The DMX signal receive IC damaged
4) DMX address error
No DMX signal
1) Check all signal Cables
2) Check all signal conncetions
3) Check the DMX signal receive IC
4) Check DMX address
1) The heat sensor resistance of LED board
error
2) The temperature protection circuit on the
display error.
When the surface
temperature of the
unit exceed 75 , the
temperature protection
no work .
1) Replace the heat sensor resistance.
2) Check the temperature protection circuit.
1) Check LEDs joining
2) Check lens installing
1) LED not joining well
2) Lens not installing well Color mixing
uneven,with splash
1) LED damaged
2) LED damaged or Main PCB LEDs of the same
color are not lit 1) Replace LEDs
2) Replace damaged LED or Main PCB
1) Replace saving IC 1) Saving IC damaged Manual and program
can not save
20 5 APPENDIX
5
APPENDIX
1) Check driver current of the partial color
LEDs on the Driver PCB
2) Check LED quality
3) Reset to factory default setting. 1) The current of one of the color group LEDs
is too strong or too weak.
2) LED brightness not enough Partial color
partial red,partial
green, partial blue
or partial white
2010.1.15 2010.1.15