T H M
C L A V I C U L A X C
E
19
LOREM
IPSUM
ASSEMBLY
Mounting the crankset
Before mounting the crankset, please check if the bottom bracket is correctly installed and runs
smoothly. For BSA MTB 73, Shimano PF 92 and PF30, please check if the sealing is mounted. This
description is only valid if you use THM bottom bracket which are designed for the THM cranksets.
If you use non THM bearings, please check if the width (see Specifications) of the
bearings allows for the cone sleeve to be installed in the correct position as described
in this chapter.
-
Locate the
spacer
(4)
required for
your bottom brackt on the cone sleeve
(3).
(See p. 10 ff).
-
Press the cone sleeve in the bearing
on the non-drive side (left).
-
Place the
spacer
(6)
required for
your bottom brackt onto the axle.
(See p. 10 ff).
-
Lightly grease the bearing seat of the
axle.
-
Insert the axle of the right crank through
the bottom bracket up to its stop.
-
Thoroughly degrease the axle and
crank multi-tooth segment.
-
Make sure that the clamping screw
(2)
is loosened or removed.
-
Fit the left crank arm to the multi-
tooth segment of the axle.
-
Press the cranks together by hand as
far as possible. Both cranks abut
against the spacer rings.
WARNING
4
3
1
2
6