T H M
C L A V I C U L A X C
E
18
LOREM
IPSUM
ASSEMBLY
Installation of the chainrings
The Clavicula XC is designed for a single chainring setup. The spider has 4 holes in a 104 mm
diameter. To carry the load of the screws and to protect the carbon surface we strongly
recommend placing some special washers between the crankset and the screw (see below)
Danger of damage to the chainring mount.
-
The number of chainwheel teeth must never be less than the minimum number
required
–
see page 10.
-
Always observe the tightening torques specified by the manufacturer of the
chain ring bolts; however, do not exceed a max. tightening torque of
6 N·m
(53 lbf·in)
under any circumstances.
Install 1 chainring
-
Place the chainring nut
(1)
in the chainring hole
-
Place both on the crank
and place the chainring on
the inside.
-
Apply grease on the
screws
(2)
-
Place the washer
(3)
between screw and
crankset
-
Tighten the screws
(2)
to
6 Nm
WARNING
1
3
2
Torx TX30 -
> 6 Nm