THK 9x0 Series, User Manual

Page: 21 / 59

Web interface
Page 21
Traps for SNMP v1/ v2/ v3
Traps are used by the camera to send massages to a management system for important events or status changes.

Enable Traps
Check the box to activate trap reporting.

Trap address
Enter the IP address of the management server.

Trap community
Enter the community to use when sending a trap message to the management system.
Trap Option

Warm Start
A Warm Start SNMP trap signifies that the SNMP device, i.e. IP camera, performs a software reload.
Click the Save button to confirm the settings.
3.2.3.4 UpnP
UPnP Setting

Enable UPnP
If UPnP is enabled and whenever the camera is presented to the LAN, the icons of the connected cameras will
appear in
My Network Places to allow for direct access.
Note: To enable this function, make sure the UPnP component is installed on the computer. Refer to Appendix
A: Install UPnP Components for the UPnP component installation procedure.

Enable UPnP port forwarding
If UPnP port forwarding is enabled, the camera is allowed to automatically open the web server port on the
router.
Note: To enable this function, make sure that the router supports UPnP and that it is activated.

Friendly name
Enter a name for the camera for identity.
Click the Save button to confirm the settings.
3.2.3.5 Diamond Protocol
To enable the Diamond protocol via IP communication, select the transport option, TCP or UDP, and configure the
corresponding listening port number, to which the PTZ commands will be sent to the camera.
Before doing so, make sure that Diamond Protocol is selected in the PTZ > RS485 pane.
- Enable PTZ commands over TCP: Enables Diamond commands via TCP.
o
Listening on Port: Port number used to send the PTZ commands via TCP.
- Enable PTZ commands over UDP: Enables Diamond command via UDP.
o
Listening on Port: Port number used to send the PTZ commands via UDP.
To enable Diamond protocol via serial RS485, PTZ commands over TCP and UDP should be disabled.
3.2.4 DDNS
The DDNS category on the left gives access to the DDNS parameters. Dynamic Domain Name System (DDNS) allows a
hostname to be constantly synchronized with a dynamic IP address. In other words, it allows those using a dynamic IP
address to be associated with a static domain name so others can connect to it by name.
Enable DDNS
Check the box to enable DDNS.