Thitronik WiPro III, Operating Instructions Manual

Page: 18 / 68

2.1 Expanding WiPro with wireless accessories (easy add)
Additional wireless magnetic contacts, radio cable loops, wireless remote controls
and wireless gas alarms can be stored in the unit during initial installation as
described in the installation manual (Chapter 1.8). Once installed, the WiPro III
can be expanded / deleted later at any time
Activating assignment by wireless remote control
1. Close driver‘s cab doors
2. Disconnect power supply from the main unit (remove fuse or plug)
3. Reconnect power supply
4. On a remote control which has already been assigned, press the button
5 times consecutively within 30 seconds ( This will cause WiPro to change
status several times; the Assign mode is indicated when the status LED
is illuminated)
5. Initiate / confirm new accessories
(WiPro acknowledges each successful assignment
by sounding the internal beeper)
6. Again, disconnect and reconnect the power supply
The new accessories are now assigned and ready for use.
Deleting wireless components using the wireless remote control :
1. Close driver‘s cab doors
2. Disconnect power supply from the main unit (remove fuse or plug)
3. Reconnect power supply
4. On the remote control which was assigned first (master remote control)
press the button 5 times consecutively within 30 seconds
(this causes WiPro to change status several times, clearing the memory
and finally switching to Assign mode. The clearing of memory is confirmed
by one long beep.)
5 Either assign new accessories or continue with step 6.
6. Again, disconnect and reconnect the power supply
All accessories are now deleted, with the exception of the master remote control.
Activating assignment by CAN bus
1. Disconnect power supply from the main unit (remove fuse or plug)
2. Reconnect power supply
3. Now, open / close the driver‘s door five times in a row within 30 seconds.
( WiPro will indicate Assign mode by illuminating the status LED)
4. Initiate/confirm new accessories
(WiPro acknowledges each successful assignment
by sounding the internal beeper)
5. Again, disconnect and reconnect the power supply
The new accessories are now assigned and ready for use.
Deleting is not possible using the CAN bus.
WiPro III Operating Instructions Page 7
GB