ThingMagic Mercury xPRESS, Platform Manual, Page: 92 / 146

A D I V I S I O N O F T R I M B L E
92
Using the Developer Toolkit
product_info.php?products_id=4650 .
The Schematic can be found here:
http://microcontrollershop.com/download/ARM-JTAG_20-10-schematic.pdf and ARM-JTAG_20-
10-schematic.pdf
JTAG Hardware Installation
1. Unplug power from both the SAM-ICE (or other J-Link-based device) and the target
board. While not strictly necessary, it is safest to connect the two while powered
down.
2. Connect the SAM-ICE to the target board with a JTAG cable. Make sure the
connector and cable are oriented as shown below.
3. Plug the SAM-ICE into a USB port on the debug host computer.
4. Power up the target board. (This is most easily done by moving the Always-on jumper
to the “On” position - See the Quick Start Guide.)
5.
Activate USB
Ensure that the USB port to the J-Link is active
Linux JLINK Software Installation (JLinkGDBServer)
The following instructions are for installation on a LINUX system. Skip to the next section
if you are using a Windows-based system.