2/13
THAN0186_Rev.1.
1
0_E
Copyright(C) 2015 THine Electronics, Inc.
THine Electronics, Inc.
Security
E
4. Power Supply Setup
This chapter shows power supply condition.
Caution: Please check if there is no power-GND short on below red trace before supplying any power.
3.3V Power Supply to Each Board
Each evaluation board requires 3.3V power supply. Please use “CON1” connector typically.
(a)THEVA213-V3
(b)THEVA214-V3
Figure 3 Power Supply for Evaluation Board
Power Supply from / to Connector
3.3V power supply can be connected to Header1 and CON2 by using W1, W2 and W3solder jumper.
THEVA213-V3
W1: Connect the 3.3V power supply with pin#1, 2 and 3 of Header1.
W2: Connect the 3.3V power supply with pin#13 and 14 of CON2.
W3: Connect the 3.3V power supply with pin#11 and 12 of CON3.
(a)THEVA213-V3 (Top
Side
)
(b) THEVA213-V3 (Bottom
Side
)
Figure 4 THEVA213-V3 Power Supply from / to Each Connector
W3
