Thiele Streamfeeder V-710DM, Manual, Page: 36 / 73

29 V
alue
S
erieS
V-710DM M
anual
4
How to Operate
Sequence of
Operation
Successful power-up and operation is assured if you apply the follow -
ing sequence of steps:
1: Loading material in the hopper
2: Determining stack height
3: Powering On feeder
4: Setting/adjusting speed
5: Running test cycles
6: Final check
STEP 1:
Loading Material
in the Hopper
Preshingling prevents multiple sheets from
jamming under the gate assembly at startup.
1. Start by preshingling by hand a small stack of material so it
conforms to the curvature of the gate assembly. Push in gently
to make sure lead edges touch the gate bracket assembly and
front edges of the hopper guides.
2. At the back wedge, notice how it helps lift the trailing edges
of the material off the table top and feed belts. Also notice
how the lifting helps to push the preshingled edges against the
curvature of the gate assembly.
If you wish, loading of material can be
accomplished from the front side of the inserter.
This section provides a sequence of operation for the V-710DM Uni-
versal Friction Feeder. It also provides information for
clearing a jam
and for shutdown .