Thiele Streamfeeder V-710DM, Manual

Page: 17 / 73

10
V
alue
S
erieS
V-710DM M
anual
Installation of the V-710DM Universal Friction Feeder onto the back
deck plate of an inserter is a relatively simple procedure. Several
minor modifications to the selected insert station are required prior to
mounting, wiring, and aligning the feeder.
To install the feeder, perform the following steps:
1: Removing rear guide assembly
2: Removing T-plate
3: Repositioning separator foot
4: Removing suction cup and closing off vacuum hose
5: Repositioning insert guide tabs
6: Installing feeder hold-down spring assemblies
7: Aligning feeder with insert station
8: Securing feeder to inserter
9: Installing support pedestal
10: Providing AC power to feeder
11: Initial feeder photo sensor positioning
STEP 1:
Removing Rear
Guide Assembly
At the selected insert station, remove the fasteners that hold the
inserter rear guide assembly to the inserter back deck plate. Lift rear
guide assembly off of back deck plate (Figure 2-8).
Figure 2-8. Removing Guide Assembly Rear from Inserter
Rear guide
assembly
2B:
Inserter Installation