Installation / Owner’s Manual 24
WARNING:
Do not omit the bottom trim piece. This piece is part of the combustion seal.
- Push the bottom trim piece [28] onto the front of the refrigerator.
- Put two screws [41] through the trim piece, the mounting flange, and into the floor.
- Put screws through mounting flange on the rear of the refrigerator and into the floor.
- Install the upper trim piece [40] over the control panel:
- Align the four (4) metal mounting clips on the back of the upper trim piece with the four (4) rectangular slots in the mounting
bracket of the refrigerator.
- Push the upper trim piece firmly until all four (4) mounting clips engage the rectangular slots with a “snap” sound.
!
Reverse the Door Swing
This refrigerator has cabinet hinges that allow you to change the direction the door opens by moving the hinges on a diagonal to the
opposite side.
1. Remove the doors (See Art02269):
- Remove the storage bins from the doors.
NOTE: Do not mix the upper and lower hinge pins because they are different.
- Remove and save the upper hinge pin [63] from each door.
- Pull the door latch and remove each door from the refrigerator.
- Remove and save the lower hinge pin [64] from each hinge.
- Remove the washer [254] and the RH lower hinge support [255] from the lower door.
2. Change the position of the cabinet hinges and the strike plate (See Art02271):
- Remove and save the screws from the strike plate [65a].
63
66
254
64
67
255
Art02269
65a
67b
66b
66a
67a
65b
66a
67a
66b
67b
Art02271
