NL DE
EN
FR
12
Connect to a power supply with protective earth
Avoid danger from damaged power supply cables. In the event of damage, the device must be
replaced by the manufacturer or its customer service department, or by an equivalently-qualified
person.
Ensure that the addition of this device will not overload the fuse protection in your mains.
Internal modifications to the product may cause problems if this work is not carried out by authori
-
zed and qualified technical staff. The warranty only applies if the product has not been modified in
any way, i.e. subject to it being in unchanged condition.
Connection of the device to the power supply network must take place in accordance with electric
installation standards and as specified by local laws and regulations.
The appliance must be installed at least 210 cm above floor level. The recommended height is 250
cm.
The rear face of the appliance must be positioned at least 6 cm from the wall and/or ceiling. A
minimum of 30 cm of unobstructed space must be present in front of and at each side of the
appliance.
Do not place any objects under the appliance within a radius of 100 cm.
Make sure at all times that the surface of the appliance is not in contact with other objects.
Do not position the appliance underneath a power socket.
Make sure that you place the appliance in a position where there is no risk of easily touching the
heating surface.
Make sure that the heating surface points downward.
If mounted to the wall, make sure that the appliance is positioned at least 10 cm away from the
ceiling.
Do not place combustible materials in the vicinity of the appliance.
Installation
The device should be installed in accordance with the drawing on the first page of the user manual.
Any other installation position may result in serious damage to the device.
Figure 1
The brackets supplied with the appliance must be positioned at an adequate distance from each
other:
Type
M
Thermoray 1500
60 cm
Thermoray 2400
100 cm
Thermoray 3000
120 cm
Attach part (A) of the bracket to a wall or ceiling in such a way that it can support the appliance‘s
weight.
Figure 2
Attach part (B) of the bracket to the appliance using the screws and angle brackets supplied in the
pack (C)(D).
Figure 3
Determine the desired angle for the appliance. Attach the two parts (A)(B) of the bracket to
each other using the screws supplied in the pack (C).
Never route the power supply cable along the heating surface.
3 User instructions
The appliance's heating surface gets extremely hot. Never touch the appliance when it is switched
on.
After use, always allow the appliance to cool down for at least 30 minutes before touching it.
