Owner’s Manual KAC/KHP/KAC-M/KHP-M Series
ThermoPlus Air, Inc. February 2007 3
Data subject to change without notice.
Set Display Address Startup
To set the display address, follow these instructions.
1. If safe to do so, turn on the electric power to the unit.
If the display shows “Humidity” and other information, no further action
is needed. If not, proceed to step 2.
Display address
setting . . . . . . . . . . . : aa
I/O Board address : bb
Default Screen
HUMIDITY
aaa / bbb %
ROOM AIR ccc / ddd F
xxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxx
Prg
Esc
2. Simultaneously press and hold the , , and buttons for at least
five seconds. The screen at right will appear, where
aa
and
bb
are
numbers.
Display address
setting . . . . . . . . . . . : aa
I/O Board address : bb
3. Press . The cursor will move to
aa
, as shown.
Display address
setting . . . . . . . . . . . : 0
4. Press until
aa
equals 0.
blinking cursor
Display address
changed
5. Press . Note that “I/O Board address : bb” disappears. The screen
at right appears briefly, followed by the unit default screen.
