TC 816 Operation Manual
THERMON…The Heat Tracing Specialists
®
Page 12 of 42
Operation Manual 0503 E TC 816
Password Input
When in the General Settings Menu a password is set to other than
000
(see chapter 3.3.2), the following
display will prompt you to enter the password whenever you try to change a set point. The password has not
to be re entered as long as the two brackets are shown around a set point in the display or you are still in a
parameter menu (see chapter 3.7 and 3.10).
TCD 01
Tracing Control Display
Figure 4.4
TCD 01 Tracing Control Display: Password Input
You can change the value of the password field by pressing the
or
buttons below
PASSWORD
to
the password which was set in the General Settings Menu.
The password value is entered with the
ENTER
button
. If the password is correct the TCD 01 continues
to the desired Parameter display or to the General Settings Menu.
