7
26-1-16
SAFETY THERMOSTAT:
Located within the control enclosure, and not accessible to the operator, is a safety
thermostat set turn the element off when the temperature rises above 65ºC.
ELECTRICAL - POWER LEAD (at rear)
A removable mains power lead with a three pin plug and right angle female IEC
socket is supplied for connection between the male IEC socket located at the side of
the bath, and a ten (10 Amp general Purpose Outlet) (G.P.O.)
OPERATION
WARNING: 1.
To avoid injury do not use flammable solvents in this
bath, as fire or explosion may result. This bath contains components
that may ignite such materials.
WARNING: 2.
Do not introduce water into the well (it is not a bath) as
it may result in component failure.
OPERATING THE FLOTATION BATH:
1) Ensure that the bath is located as previously described, refer to the index,
LOCATION, Place the glass dish into the well and fill it with water to a
maximum depth of 40mm.
CAUTION:
Ensure that the ventilation for the
rear cooling fan are not obstructed.
2) Place the main switch in the ON position (reset), and immediately the
controller will be activated.
3) The temperature controller is a Brainchild BTC901 analogue instrument. Each
division on the temperature scale represents 2ºC. Turn the pointer to the desired
temperature and allow sufficient time for the water in the dish to reach the
operating temperature (55ºC for most waxes). The lid may be in place to speed
up heating.
Warning:
Contact with hot fluid of the bath may
result in personal injury. Ensure appropriate
protective equipment and procedures are
applied at all times.
4) When the set temperature is reached, remove the lid (cover), and allow time
for the temperature to stabilise again. Adjust the temperature if necessary.
5)
To turn on the viewing light, simply press the light switch and release, the fluorescent
light will then be illuminated. To turn off the light press and release the light switch again.
