13
USE AND CARE INSTRUCTIONS
Never
test for leaks with an open flame. Prior to first
use, at the beginning of each season, you must check
for gas leaks. Follow these three steps:
Check For Gas Leaks
WARNING
!
Failure to read and follow the Use and Care
Instructions could result in a fire or explosion
that could cause serious bodily injury, death
or property damage.
!
Make a soap solution by mixing one part liquid
detergent and four parts water.
1.
2. Pull the
black
string down until
‘
click
’
will be heard
and then release, then turn on gas at source.
1 part liquid detergent
4 parts water
GAS REQUIREMENTS
TGH34WN(NG) Model:
This appliance is for use with Natural Gas only.
Ensure that inlet pressure to the regulator does
not exceed 5.0 Kpa.
The approved inlet pressure to be 1.0 Kpa.
Apply the soap solution to all visible gas connections.
If bubbles appear in the soap solution the
connections are not properly sealed. Check each
fitting and tighten or repair as necessary.
3.
WARNING
!
!
If you have a gas leak that cannot be repaired
by tightening, turn off the gas at the source,
disconnect fuel line from your heater and call
(03)
9562 3455 or your gas supplier for repair
assistance.
TURN ON (Red)
TURN OFF (Black)
NG Model
ULPG Model
Summary of Contents for HEATSTRIP TGH34WL
Page 9: ...Parts Diagram 9...
