13
ENSURING BURNER CONTROLS ARE OFF
IMPORTANT: Before connecting and disconnecting
barbecue to gas source, ensure burner controls are in ‘OFF’
position.
NOTE: The ‘OFF’ position on the control panel is identified
by either a small black dot / a short vertical black line / or
the word ‘OFF’.
CAUTION:
When the appliance is not in use, the gas must
be turned off at the gas cylinder.
Familiarise yourself with the general information and safety
guidelines located at the front of this booklet. Check to see
that gas cylinder is filled and that end of
each burner tube is properly located over each valve orifice.
Set burner controls to ‘OFF’ position.
TO GAS SOURCE
Locate the gas cylinder in the cabinet and secure.
1
.
Attach the regulator and hose assembly to cylinder
2
.
valve outlet. Tighten firmly.
Open the gas cylinder valve fully to allow gas to flow.
3
.
Leak test all accessibleconnections thoroughly using a
4
.
soapy water solution prior
to lighting the barbecue.
Refer to Safety information,
page 5.
If a leak is found, turn gas
5
.
cylinder valve off and re-
check all connections have
been tightened. If there
is still a leak do not use
barbecue until repairs or
replacement can be made.
DISCONNECTING FROM GAS SOURCE
Turn the burner controls ‘OFF’ .
1
.
Turn the gas cylinder valve off fully.
2
.
Detach the regulator assembly from gas cylinder valve.
3
.
NOW YOUR BARBECUE IS READY TO USE
Before first use and at the beginning of each barbecue
season:
Please read Safety, Lighting and Operating instructions
1
.
carefully.
Check gas valve orifices, burner tubes and burner ports
2
.
for any obstructions. eg. spiders, webs, insects.
Check and ensure the gas cylinder is full.
3
.
Ensure all connections are securely tightened. Check
4
.
for gas leaks.
CONNECTION TO A FIXED GAS SUPPLY
When connecting to a fixed gas supply the installation must
be in compliance with
AS/NZS5601.
IMPORTANT
Direction for
tightening
ENSURING BURNER CONTROLS ARE OFF
CONNECTING TO AND DISCONNECTING FROM GAS
SOURCE
DISCONNECTING FROM GAS SOURCE
NOW YOUR BARBECUE IS READY TO USE
CONNECTION TO A FIXED GAS SUPPLY
Before connecting and disconnecting barbe-
•
cue to gas source, make sure burner controls
are in “OFF” position.
When the barbecue is not in use, the gas must
•
be turned off at the cylinder.
The appliance control knob must be in the
•
“OFF” position before opening the cylinder
valve.
Disconnect and remove gas cylinder when
•
manoeuvring the barbecue over uneven
surfaces or carrying up and down stairs.
Check that the seals between the appliance
•
and the gas cylinder are in place and in good
condition before connecting the gas cylinder.
Do not use this appliance if it has damaged or
•
worn seals.
