Read the following steps before performing any of them. It will allow you
to familiarize yourself with the procedure and to determine the values you
want beforehand.
Note
In the following setup mode, there is a five (5) second time-out
feature that is active following each entry. If the five (5) seconds is
exceeded, the unit will return to the normal operation mode. If the time-
out occurs before the value was entered, start over.
s
1. With the growth chamber ON, simultaneously press and hold the UP
and DOWN keys, then press the ENTER key. The letters will be
shown in the display. A number other than 96 might be shown in the
display:
Choose the number appropriate for the Baud Rate desired.
3 = 300
6 = 600
12 = 1200
24 = 2400
48 = 4800
96 = 9600
Press the UP or DOWN key until the display shows your selection.
Press ENTER. The baud rate has been entered.
2. The display should change to the following. Again, the number in the
display might be different than 0.1, but it will have a decimal point.
Choose the number appropriate for the Status Update Time Interval
desired.
0.0 Minutes . . . . . . . . . . . . . . . . . . . . . No report
0.1 Minutes . . . . . . . . . . . . . . . . . Between reports
0.5 Minutes . . . . . . . . . . . . . . . . . Between reports
1.0 Minutes . . . . . . . . . . . . . . . . . Between reports
2.0 Minutes . . . . . . . . . . . . . . . . Between reports
5.0 Minutes . . . . . . . . . . . . . . . . . Between reports
10.0 Minutes . . . . . . . . . . . . . . . . Between reports
30.0 Minutes . . . . . . . . . . . . . . . . . Between reports
60.0 Minutes . . . . . . . . . . . . . . . . . Between reports
Plant Growth Chamber
6-3
Thermo Scientific
Section 6
Factory Options
Set Up the Incubator for
Communications (cont.)
