Isotemp Freezer
Installation | 9
5. Install the hinge bearing on the opposite side of the door.
Remove the door from the unit by lifting the door up as
shown in
Figure 4. Install the hinge bearing on opposite side
6. Flip the door over to access the bottom. Using a
screwdriver remove the screws from the hinge bearing
and the door closer as shown in
Figure 5. Remove the screws from hinge bearing
7. Using a flat head screwdriver, gently pry the closer/
bearing assembly out of the door.
8. Separate the door closer and hinge bearing. Flip the door
closer over 180º and reinstall the closer onto the hinge
bearing.
9. Using a screwdriver, attach the door closer/bearing
assembly to the opposite side of the door.
10. Remove the hinge cover by gently bending the tabs of
the cover out while pulling the cover towards the front of
the unit to remove.
11. Using a screwdriver, remove the screw from the door
stop.
12. Using a flat head screwdriver, gently pry the door stop off
the bottom hinge pin.
13. Using an adjustable wrench, remove the bottom hinge
Figure 6. Remove the bottom hinge
14. Reinstall the hinge pin into the outer hole and tighten with
an adjustable wrench.
15. Flip door stop over 180º and reinstall onto the opposite
hinge over the hinge pin.Reinstall the screw as shown in
.
Figure 7. Reinstall the screw
16. Reinstall the hinge cover by gently bending the cover
tabs outward, while sliding the cover over the hinge until
it clicks into place.
Bottom
Door
Stopper
Door
Stopper
Screw
Bottom Hinge
Pin
