Thermo Scientific Dionex ICS-5000, Operator'S Manual

Page: 174 / 482

Dionex ICS-5000 Operator’s Manual
158
Doc. 065342-06 12/11
5. If the preferred flow rate is already selected, but the pump flow is off,
click the switch to start the pump at the selected flow rate.
NOTE
After starting the pump or changing the flow rate, wait
at least 5 minutes (longer for flow rates below
1.0 mL/min) before beginning an analysis. This allows
the DP/SP to stabilize the flow rate.
6. Enter the minimum and maximum pressure limits. Setting pressure limits
ensures that the DP/SP will automatically stop if a system malfunction
occurs.
Table 4-1 lists the default pressure limits for capillary and
analytical pumps.
Pump Configuration Default Low
Pressure Limit Default High
Pressure Limit
Capillary pump not linked
to an EGC 0 41 MPa (6000 psi)
a
a. Capillary IC pumps shipped before February 17, 2011 were rated for lower
operating pressures than the pumps currently being shipped. Refer to the im-
portant note on the next page for details.
Capillary pump linked to an
EGC 1.4 MPa (200 psi) 35 MPa (5000 psi)
b
b. If the installed version of EG degas (capillary) cartridge is not rated for
35 MPa (5000 psi), change the default high pressure limit to 21 MPa
(3000 psi). Refer to the important note on the next page for details.
Analytical pump not linked
to an EGC 0 35 MPa (5000 psi)
Analytical pump linked to
an EGC 1.4 MPa (200 psi) 21 MPa (3000 psi)
Table 4-1. Default Pressure Limits for DP/SP Pumps