12 | Emerald Bluetooth Enabled Wireless Remote Sensors
Compatible Sensors for Smart-Vue Pro Duo / Quatro Data Logger
Identifying the Strong Side of
the Magnet
The magnet has a “weak” side and a “strong” side. Here is a
hint to help you identify which side is which: the metal ring
inside the hole is close to the edge on the “weak” side of the
magnet. The deeper recess on the other side indicates the
“stronger” side.
Figure 5. Strong vs weak side of the magnet
Mounting your Emerald
Sensor
Using the Magnet
You may use the magnet to mount your sensor on
appropriate surfaces (wood, plaster, etc.). To do this, run a
screw through the central hole to fasten the magnet with the
strong side (non-adhesive) facing the Emerald then place the
sensor onto the magnet as shown here:
Figure 6. Mount the sensor on the magnet after
fastening it to a suitable surface
Using Adhesive Tape
You may also choose to mount the Emerald sensor using the
provided adhesive tape.
Note:
Clean the magnet before using the adhesive tape on it.
Using Wireless Remote
Sensors with your Data
Loggers
Pairing a Bluetooth Wireless
Remote Sensor
The Smart-Vue Pro data logger supports both wired and
wireless remote sensors. As mentioned previously, wired
sensors are detected and configured automatically by the
data logger when they are physically plugged into the unit.
Pairing the Smart-Vue Pro data logger with a wireless remote
sensor is easy when following the guided touch screens
below:
To pair your wireless remote sensor:
1. Tap the menu icon
Sensors
Remote sensors.
2. Enter your PIN code as configured in the Smart-Vue Pro
web application and tap
OK
.
3. Tap
Pair remote sensors
.
Deeper recess on strong
side of the magnet.
Shallow recess on weak
side of the magnet.
CAUTION:
This section covers supported
Emerald Bluetooth sensors (firmware version
2.3.2 or higher; check with your authorized
representative if you need more information).
