Thermo Scientific Agilent 1100 Series, Getting Connected Manual

Page: 15 / 32

2
Connecting the Hardware
Installing a Network Card in an Agilent Module
Thermo Scientific Agilent 1100 Series Getting Connected Guide for LC Devices 5
 To install the network interface card in an Agilent module
1. Make sure the module (usually the detector) is turned off and unplugged from line power.
Figure 3 shows the location of the power switches.
When the power switch of a module is in the On position, the LED on the switch is
green. When you turn the power switch of a module to the Off position, the LED
turns off.
If your LC stack contains a detector (for example, a diode-array detector, variable
wavelength detector, or multiple wavelength detector), install the network interface card
in the detector. If your LC stack does not contain a detector, install the network card in
any module with an open slot.
Figure 3. Power switches on the front of the Agilent 1100 Series modules
CAUTION
To avoid electric shock, unplug the power cable that connects the Agilent
module to line power. After you turn the power switch to the Off position, the power
supply continues to draw current.
Note You can install an Agilent LAN interface board (Model G1369A) instead of a
JetDirect 400N network card.
Binary pump
Autosampler
Column
compartment
Detector
On
position
Off
position