Installation
of Tube Holder
Caution:
When replacing the accessories, remove
power from the instrument by unplugging.
Tube Holders are suitable for "Continuous"
mode to mix samples by test tubes.
1. Parallel place the Tube Holder on the
top of the base tray.
2. Align the inner bump of
the Tube Holder
is
to
the
groove
on
the base tray.
gently
press both sides of the Tube Holder to
snap it onto the base tray, and please
make sure it tighten.
3. Install the corresponding EVA sponge
pad on the Tube Holder, after inserting
the test tube into the EVA sponge pad,
the instrument can than be turned on
.
Note:
(1). When mixing by ELISA PLATE,
the
capacity
of
the
ELISA
PLATE
shall
not
exceed 1/2 of
the maximum
capacity. Otherwise,
there
may be
liquid splash.
(2). When Microplate Trap(88882122) is
used with Deepwellplate, the
capacity
of
the
Deepwellplate
shall
not
exceed 2/3 of
the maximum
capacity, and the maximum speed
not exceed
650rpm.
(3). The
Recommended
speed
values
in
the
table
are
for
reference
only
(Section Optional Accessories).
Change
the
speed
value
according
to
the actual operation
of
the
instrument.
Step2
Push
Push
9 Section 5 | Operation
Basic Vortex Mixer 10
Step1
Step2
Push
Push
5.3 Settings
Please confirm the environmental condition
and the power voltage first, and then, connect
the
mixer power
cord
to the
power outlet,
Ensure the machine is on a flat surface
prior to operating.
Switch On
Press the
power switch
to position “
I
”
and
the
display window is shown as
below:
The corresponding indicator for the
running mode is on.
Mode Settings
In standby, press “ ” button to switch
“Touch” mode or “Continuous” mode. In
“Touch" mode, the instrument starts
running automatically when the vessel
presses on the Rubber Platform or Flat
Bottom vessel Platform, and automatically
stops when the vessel leaves the platform.
In “Continuous” mode, press “ ” button,
the instrument with tray, platform or tube
holder starts running continuously, and
press “ ” button again, the instrument
stops running.
Run
Stop
Run
Stop
Speed
setting
Turn the speed knob clockwise or
counterclockwise, the Speed display
window to set the target speed, for
example:
In this case, the set speed is 1600rpm.
Press the Speed setting knob, the digital
tube starts flashing, turn the knob to
adjust the display window value to
1600,then press the knob again within
5s,the digital tube stop flashing, the
display window shows 1600,the speed
setting is finished.
Power Recovery
Continuous Mode: If the power is cut off
suddenly while the instrument is in
operation, the instrument will resume the
parameters set before the power is cut
off, but the instrument will not continue
to run.
Touch Mode: The power is cut off when
the instrument is working. If the power is
on again, the instrument will resume the
parameters set before the power is off,
put the vessel onto the Rubber Platform
or Flat Bottom Vessel Platform and
press to run.
Finish Operation
After use, please press power switch to
turn off the power. Unplug the instrument
and store it according to the storage
guide.
1 6 0 0
Speed display window
0 2 0 0
Flat angle
match
Base Tray
Tube Holder
EVA Sponge Pad
Tube Holder
Step3
Step2 Detail View
Step2 Detail View
Groove
alignment
Groove
alignment
