Thermo Forma 3940, Operating And Maintenance Manual

Page: 13 / 42

Models 3940 and 3949 ________________________________________________________________Installation and Set-Up
2 - 7
3940 (WATLOW 982) CONFIGURATION RECORD
CUSTOMER:
JOB NUMBER:
UNT SERIAL NUMBER:
CONTROL TYPE: Humidity
PERPARED BY: DATE:
COMPLETED BY: DATE:
Switch Configuration:
Main Boards Input 1 Board Output 3 Option board
SW1 ON SW1 ON Jumper switch setting:
SW2 ON SW2 ON Form B
SW3 ON
Software Configuration:
Operations Menus
SYS:
Ei1S NA Ent4 NA A3LO 0* A4Hi NA
Ei2S NA A2LO NA A3Hi 100* Aut OFF
Ent3 NA A2Hi NA A4LO NA
* These values are customer setable to there alarm points.
PID: Pb1 8 dE1 NA It2 NA dB 0
rE1 0.05 Ct1 5.0 rA2 0.35
It1 NA Pb2 7 dE2 NA
rA1 0.35 rE2 0.03 Ct2 30
PROG: See Programming Sheets if required.
Setup Menus
InPt:
In1 0-5 CAL1 ** rL2 NA CAL2 NA
dEC1 0 rtd1 NA rH2 NA Hunt NA
rL1 0 Ftr1 2 LrnL NA
rHi 100 In2 NA LrnH NA
OtPt: Ot1 Ht AL2 NA LAt3 nLA SIL4 NA
PrC1 NA LAt2 NA SIL3 ON Aout NA
HyS1 1 SIL2 NA Ot4 NA PrC3 NA
Ot2 CL Ot3 AL3 AL4 NA ArL NA
PrC2 NA AL3 Pr1 HyS4 NA ArH NA
HyS2 1 HyS3 1 LAt4 NA ACAL NA
gLbL: C_F NA Anun ON PtyP ti PStr StPt
Err nLA LoP -100 gSd 0 LOC 2 *
Ei1 NO HiP 100 POut Cont
Ei2 NA AtSP 90 IdSP NA
* LOC should be set at 0 until factory testing and calibration is complete.
** This is a calibration factor and will vary from unit to unit.
COM: bAUd 9600 dAtA 70 PrOt FULL Addr 0
IntF NA