Connecting Cables
6
Mounting Hardware
4
Connecting Water Supply
5
•
Connect the 3 1/2” x 1/4” all-thread rod bolts (studs) together with
supplied couplings.
•
Insert the 3 1/2” x 1/4” studs from the shower side into the 7/16” pre-
drilled holes. Hold it in place while from the top side of the cut out insert
supplied spring, washer and secure it with provided wing nut.
•
Tighten retaining spring to half its normal height (shown on page 14)
Repeat the above steps for all three studs
NOTE:
Make sure to flush out any debris from the pipe before
connecting the fixture!
You will need a 36” flex water supply that connects to your water pipe
that you plumbed for the Rain Head. The connection to the Rain Head
needs to be 3/8” compression. Please connect the 36” flex water
supply from the water source to the Rain Head. Do NOT over tighten.
Slowly open the water and check for leaks before proceeding.
Flex Water Supply
Connect the Audio cable that is connected to the
ThermaTouch control.
•
Red to (R), White to (L), and make sure that both cables are
connected to the same Input “1” or Input “2”.
•
At this point IF you have any other audio source to be connected
please do it now to the open Input on the Rain Head.
•
Next, connect the M12 power/data cable that runs or will run to the
Power Distribution Module (PDM).
NOTE: Make sure that the “L” shaped end of M12 cable is
connected to the Rain Head
Audio Cable
from ThermaTouch
control
M12 power/data
cable to PDM
16
16
THERMASOL.COM
I
800.776.0711
Wellness Steam Package
