FIREpOwER Fp-95
INSTALLATION
Manual 0-5122
3-4
Installation
3. Open Pressure Arm (Fig. 3-4).
4. Place the end of the wire into the Inlet Wire Guide,
feeding it over the Feedroll. Make certain that the proper
groove is being used (Fig. 3-5).
5. Pass the wire into the Gun Liner of the Gun Cable End
(Fig. 3-5).
6. Close the Pressure Arm (Fig. 3-5).
7. Close the Pressure Adjust Device. Tighten it to a “snug”
condition (Fig. 3-6).
8. Figure 3-6 shows the result with the wire installed.
NOTE
If there is too much pressure on the drive roll
the wire gets locked and the motor could get
damaged, If it is too loose the wire will not
feed properly.
Pressure Adjust Device
Pressure Arm
Art # A-09070
Figure 3-4: Opening Pressure Arm
Pressure Adjust Device
Pressure Arm
Wire Spool
Wire
Feed Roll
Art # A-09071
Figure 3-5: Inserting Wire
Art # A-09072
Figure 3-6: Wire Installed
