INSTALLATION
FIREpOwER Fp-95
Installation
3-3
Manual 0-5122
3.07 Feedrolls
A feedroll consists of two different sized grooves. As
delivered from the factory, the drive roll is installed for
.030" (0.8mm) Firepower FP-95.
The branding inside at the end of the feedroll refers to the
size nearest to the mark
This also applies to optional feedrolls which are available
for this machine.
.030
0.8
Art # A-07963
Figure 3-2 : Feedroll Example
3.08 Install Wire into the Feedhead
WARNING
ELECTRIC SHOCK CAN KILL! Make certain
the machine is unplugged from the power
receptacle. Do not plug machine in until told
to do so in these instructions.
If Not Installed Load the Wire Spool per directions in sec-
tion 3.06 onto the hub so that the wire will feed off the
spool as the spool rotates counter- clockwise.
CAUTION
Use care in handling the spooled wire as it
will tend to “unravel” when loosened from the
spool. Grasp the end of the wire firmly and do
not let go of it. Make sure that the end of the
wire is free of any burrs and is straight.
Pressure Adjust Device
Pressure Arm
Gun Cable
Wire Spool
Inlet Wire Guide
Feed Roll
Art # A-09069
Figure 3-3: Wire Feeder Components
Route the Wire Through the Feedhead
1. Loosen Pressure Adjust Device (Fig. 3-3).
2. Open Pressure Adjust Device (Fig. 3-3).
