Fabricator 181i
Manual 0-51
91
2-1
INTRODUCTION
SECTION 2:
INTRODUCTION
2.01 How to Use This Manual
This Manual usually applies to the part numbers listed
on page i. To ensure safe operation, read the entire
manual, including the chapter on safety instructions and
warnings. Throughout this manual, the word WARNING,
CAUTION and NOTE may appear. Pay particular attention
to the information provided under these headings. These
special annotations are easily recognized as follows:
!
WARNING
Gives information regarding possible per-
sonal injury. Warnings will be enclosed in a
box such as this.
CAUTION
Refers to possible equipment damage. Cau-
tions will be shown in bold type.
NOTE
Offers helpful information concerning cer-
tain operating procedures. Notes will be
shown in italics
You will also notice icons from the safety section ap-
pearing throughout the manual. These are to advise you
of specific types of hazards or cautions related to the
portion of information that follows. Some may have
multiple hazards that apply and would look something
like this:
2.02 Equipment Identification
The Power Source's identification number (specifica-
tion or part number), model, and serial number usually
appear on a nameplate attached to the machine. Equip-
ment which does not have a nameplate attached to the
machine is identified only by the specification or part
number printed on the shipping container. Record these
numbers for future reference.
2.03 Receipt of Equipment
When you receive the equipment, check it against the
invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If there
is any damage, notify the carrier immediately to file a
claim. Furnish complete information concerning dam-
age claims or shipping errors to the location in your area
listed in the inside back cover of this manual. Include
all equipment identification numbers as described above
along with a full description of the parts in error.
2.04 Description
The Thermal Arc Fabricator 181i is a self contained
single phase multi process welding system that is
capable of performing MIG (GMAW/FCAW), STICK
(SMAW) and LIFT TIG (GTAW) welding processes. The
Power Source is equipped with an integrated wire feed
unit, digital voltage and amperage meters, and a host
of other features in order to fully satisfy the broad op-
erating needs of the modern welding professional. The
Power Source is also fully compliant to Standard CSA
E60974-1-00 and UL 60974.1.
The Fabricator 181i MIG provides excellent welding
performance across a broad range of applications when
used with the correct welding consumables and proce-
dures. The following instructions detail how to correctly
and safely set up the machine and give guidelines on
gaining the best efficiency and quality from the Power
Source. Please read these instructions thoroughly be-
fore using this equipment.
2.05 Transportation Methods
!
Disconnect input power con-
ductors from de-energized supply line before moving
the welding Power Source.
Lift Power Source with handle on top of case. Use
handcart or similar device of adequate capacity. If using
a fork lift vehicle, secure the Power Source on a proper
skid before transporting.
Summary of Contents for FABRICATOR 181i
