SECTION 6: GETTING STARTED
6.01 Torch Connection
Fit the MIG Torch
(2)
to the Euro adaptor
(1)
by pushing the torch connector into the
brass torch adaptor and screwing the plastic torch nut clockwise to secure the torch to
the torch adaptor. Remove the contact tip from the torch handset.
If a water cooled sys tem is in us e then c onnect the coolant c onnections
(5)
of the
torch with the sockets
(3)
and
(4)
. Connect the red fitting together and the blue fittings
together.
Figure
13
.
6.02 How to connect the work lead
Connect the work lead
(7)
to one of the two Negative connections
(6)
and fasten it by
turning the connector to the right. Connect the Work clamp
(
2 - figure 13
)
to the work
piece or at
the welding table.
Figure 1
4
.
6.03 Where to connect the work clamp
Fasten the Work clamp near the welding location, this avoids stray current flow
through mains earthing system.
32
Summary of Contents for C/W VFE 4C HS III
