Thermador DWHD860RFM, Use And Care Manual

Page: 29 / 84

29
Using the Star Speed cycle
1.
Open the door and press the
ON/OFF
button
(
2.
Press the
Star Speed
button. The dishwasher should
be empty and without detergent for the preheating
period.
3.
Press the
Start
button
)"
and close the door to
begin preheating. The Time Remaining PowerBeam®
will show an “
H
” alternating with the time remaining for
preheat. Once the time reamining counts down to
“
0:00
” the Time Remaining PowerBeam® will show an
–
.
4.
Open the door to begin loading dishes for the first Star
Speed™ wash. (Load dishes within an hour once the
preheating is finished).
5.
Add detergent (use powder or liquid detergent – do
not use tablets in this cycle), press
Start
button
)"
and close the door within 4 seconds.
6.
The Time Remaining PowerBeam® will now show
“
Turbo Speed
” alternating with the time remaining.
7.
When the cycle is done, the Time Remaining
PowerBeam® will turn off.
8.
The next Star Speed™ cycles can run without any
preheating (maximum of 60 minutes in between
cycles).
Wash cycle end
The wash cycle has ended when “Finished” is indicated
on the digital display
@
and
):
.
Switching off the appliance
Short time after the end of the wash cycle:
1.
Press
On/Off
button
(
.
2.
Turn off water supply.
3.
Remove the utensils when they have cooled down.
9
WARNING
RISK OF INJURY
To avoid risk of injury, always use caution when
opening the door during or following a wash cycle
as hot water or steam may escape. Do not fully
open the door until water noises have stopped and
steam has subsided.
Interrupting the wash cycle
9
CAUTION
Expansion (overpressure) may cause the appliance
door to open and/or water to escape! If the door
was opened on an appliance which has a hot water
connection or is heated, always leave the door ajar
for several minutes and then close.
1.
Open the door.
2.
Switch off On/Off switch
(
.
The LED’s go out. The wash cycle is saved.
3.
To continue the wash cycle, switch on the On/Off
switch ( again.
4.
Close the door.
Note:
Your dishwasher is protected against unintentional
operation. If the appliance door remains open for more
than 4 seconds after pressing the Start button, the
operation will be paused. Press the Start button again
and close the appliance door.
Cancel a cycle (reset)
1.
Open the door and press and hold the
Start
button
)"
for approximately 3 seconds until the digital
display
@
shows: "Program was terminated".
2.
Close the door.
3.
Wait about 1 minute while the dishwasher drains.
4.
Open the door and press the
On/Off
switch
(
.
Changing the wash cycle
When the
Start
button
(
has been pressed, the wash
cycle cannot be changed. The only way a wash cycle can
be changed is by terminating the wash cycle (Reset).