HWS
Shut-off
valve
Hot water supply line
(520 mm)
20 1/2"
WARNING
ELECTRICAL SHOCK HAZARD
•
DISCONNECT ELECTRICAL POWER AT
THE CIRCUIT BREAKER BOX OR FUSE
BOX BEFORE INSTALLING THE
DISHWASHER.
•
ELECTRICALLY GROUND DISHWASHER.
•
USE COPPER CONDUCTORS ONLY.
FAILURE TO FOLLOW THESE
INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
23-
5
/
8
" - 24"
(600 - 610 mm)
2-
3
/
8
"
(60 mm)
3-
1
/
2
"
(90 mm)
AVERTISSEMENT
RISQUE DE CHOC ÉLECTRIQUE
•
AVANT D’INSTALLER LE LAVE-VAISSELLE,
COUPER LE COURANT ÉLECTRIQUE AU
DISJONCTEUR OU À LA BOÎTE DE
FUSIBLES
•
EFFECTUER LA MISE À LA TERRE
•
UTILISER UNIQUEMENT DES
CONDUCTEURS EN CUIVRE.
SI L’ON N’OBSERVE PAS CES INSTRUCT–
IONS, IL PEUT EN RÉSULTER DE GRAVES
The electrical supply must be 120 volt, 60 Hz, 12 ampere,
properly grounded, positioned as shown in Figure 7, and
should be installed by a qualified electrician. No other
appliances or outlets should be on this circuit.
Cut a 1” (25.4 mm) diameter hole in the cabinet for the
electrical wiring to pass through. If this hole is cut in a
wood cabinet, the hole should be sanded until smooth.
Electrical Supply
Figure 7.
Access holes for electrical cord, drain line and water
line must be rounded and smooth. Holes must not be
larger than 1-1⁄2” diameter.
Hot Water Supply
•
The hot water line to the dishwasher must provide
between 5 - 120 psi (0.3 - 8.27 bars) water pressure.
•
The hot water heater should be set to deliver 140
°
F
(60
°
C) water temperature to the dishwasher.
•
A 3/8” minimum O.D. copper tubing inlet line is
recommended.
•
All solder connections must be made before water
line is connected to the dishwasher’s inlet water
valve. Do not solder within 6 inches (152.4 mm) of
the dishwasher’s inlet water valve
.
After determining where the water supply line will enter
the dishwasher, drill a 1” (25.4 mm) diameter access
hole and run the line to the approximate fill valve
location, as shown in Figure 7. It is recommended that
a shut-off valve (not supplied) be installed in the hot
water supply line in a readily accessible location.
Drain Hose
The dishwasher comes with a seven (7) foot drain hose.
An access hole must be made to allow the drain hose
to be run to the drain connection location.
Figure 6.
Preparing the Location
Openings for electrical, water and drain lines must be
installed in the marked area as shown in Figures 6 and 7
to avoid interference with the dishwasher frame or other
components.
3
