Mounting brackets
Drain hose
Hot water line
Electric supply cable
Air gap
Entry must be
above trap
Rubber connector
min. 20" (500mm)
clearance to floor
T
min. 20" (500 mm)
clearance to floor
See Fig. 2
Figure 11.
DO NOT use a drain hose or fittings less than 5/8” I.D.
Figure 12.
Drain Hose
If the 7 foot drain hose provided is not long enough, an
additional piece of hose is needed to connect the drain
hose to the sink, disposer or air gap. The rubber drain
hose must be resistant to heat and detergent. The drain
hose may be obtained from a plumbing, hardware or
automotive supply outlet.
The rear leveling leg is adjusted by turning the center
screw at the front of the dishwasher. The front leveling
legs are adjusted by rotating the front leveling legs. See
Figure 11, above.
If additional height is needed, shims may be added under
the leveler feet.
It is recommended that the cardboard or styrofoam
shipping base be kept under the dishwasher until it is
installed. The cardboard/styrofoam will help to protect
the floor during installation.
Figure 10.
Figure 13.
5
