background image

refrigerant during normal operation. A flooded evaporator 
should maintain constant pressure and temperature across 
the entire coil, from inlet to outlet. The mixture of gas and 
liquid refrigerant enter the accumulator after leaving the 
evaporator coil. The accumulator prevents any liquid 
refrigerant from reaching the compressor. The compressor 
evacuates the cool refrigerant gas from the accumulator 
and compresses it to a high pressure and temperature gas 
to repeat the process.

8.2 Troubleshooting
FOR THE HOMEOWNER:

n  

If the unit does not work properly, please check the 

following:
— Is the unit unplugged?
— Is power to outlet on? (check switch, if applicable)
— Is circuit breaker tripped?
— Is humidity control set? (turn to “ON”)
— Is air flow restricted? (check air filters and grill)
If none of the above, call dealer or 1-800-533-7533.

FOR THE HVAC PROFESSIONAL:

n

 

No dehumidification. Neither blower, nor compressor run 

with fan switch AUTO.

1.   Unit unplugged or no power to outlet, circuit breaker 

tripped.

2.  Humidity control set to “Humid” setting.
3.   Loose connection in internal wiring.
4.    Humidity control is defective.

No dehumidification. Compressor does not run but 

blower runs with fan switch AUTO and humidity control 
turned to ON.

1.  Defrost thermostat open, ambient temperature too low.
2.  Loose connection in compressor circuit.
3.  Defective compressor overload.
4.  Defective compressor or compressor run capacitor.

Blower runs with fan switch AUTO but compressor  

cycles on & off.

1.   Low ambient temperature and/or humidity causing unit
  to cycle through defrost mode.
2.  Defrost thermostat defective.
3.   Defective compressor overload.
4.   Defective compressor.

Blower does not run with fan switch in either position. 

Compressor runs briefly but cycles on and off.

1.  Loose connection in blower circuit.
2.  Obstruction prevents impeller rotation.
3.  Defective blower.
4.  Defective blower switch.

Evaporator coil frosted continuously, low dehumidifying 

capacity.

1.  Dirty air filter or air flow restricted.
2.   Defrost thermostat loose or defective.
3.  Low refrigerant charge.

If none of the above has fixed the issue, call technical 
support at 1-800-533-7533.

9. Service Parts List

Part No 

Description

4026221 

Leveling Foot

4031085 

Condensor Coil

4031086 

Evaporator Coil

4025741 

 Thermostat, Defrost Control

4029510 

Filter/Drier

4032225 

Compressor Replacement Kit

4029714 

Compressor Overload

4026657 

Impeller

4025560 

Fan Switch

4021469 

Humidistat

4017021 

Blower Capacitor, Run, 15MFD, 370V

4026687 

Compressor Capacitor, Run, 45MFD, 370V

10. Accessory/Replacement Parts List

4021475 

MERV 11 Filter (16"x20"x2")

4027420 

MERV 11 Filters 4-Pack

4027424 

MERV 11 Filters 12-Pack

4028614 

Pump Kit

4028616 

Caster Kit

4028607 

Supply Duct Kit (includes two 10" collars)

4026969 

10" Flex Duct 25'

4022126 

10" Flex Insulated Duct 25'

4028610 

Return Duct Kit (includes one 12" collar)

4024750 

12" Flex Duct 25'

4028366 

12" Flex Insulated Duct 25'

4020175 

Remote Dehumidistat

To order, contact your dealer  

or call 1-800-533-7533.

Santa Fe Max Dry Dual XT OWNER’S AND INSTALLER’S MANUAL

6

Santa Fe Max Dry Dual XT Installer’s & Owner’s Manual

Summary of Contents for 4031470










Reviews: