17
Art. no.: A005-962_Rev 01
Last update: CW34/2016
THERA-Trainer coro - User manual
START-UP
7.
START-UP
7.1. Unpacking
Unpack the THERA-Trainer coro:
Remove the THERA-Trainer coro from packaging.
Check the THERA-Trainer coro incl. all accessories/options for transport
damage.
Check if delivery is complete.
Inform supplier or forwarding agent immediately of any damage.
7.2. Set-up conditions
Ensure that the following requirements are met:
Temperature: 5 °C - 40 °C
Humidity: 15 % - 93 % Rh
Air pressure: 700 hPa - 1,060 hPa
Do not use the THERA-Trainer coro in wet, humid or hot environments.
Only use the THERA-Trainer coro on even and slip-proof floors.
Do not use the THERA-Trainer coro outside or in outdoor facilities.
7.3. Installing the THERA-Trainer coro
Connect feedback sensor type A incl. touch button
Clip the feedback sensor A incl. touch button into the fixing set for THERA-
Trainer coro.
Switch on the feedback sensor type A incl. touch button.
Plug Bluetooth receiver for sensors
2
into the USB interface
1
of the control
and display unit/computer.
The USB interfaces
1
are located on the rear, side, top, or on the bottom of the
control and display unit/computer.
Comply with the enclosed user manual.
The following elements are described in the user manual for the feedback sensor
type A incl. touch button:
Feedback sensor type A incl. touch button
Bluetooth receiver for sensors
Feedback sensor fixing set for THERA-Trainer coro
Only use the elements when connected.
