INSTALLING YOUR
MAGFLO PUMP CONT:
Plug in Pump
Plug the power cord into a standard 120-volt GFCI
protected outlet.
Submerge Pump
Submerge the MagFlo pump in a flat area in your pond. For
ideal water circulation, the pump should be at the opposite
end of the pond from where the water will discharge. If the
fountain feature will be used, be sure the spray nozzle is at
least a few inches above the water’s surface.
You may use MagFlo pumps in-line (out of the water)
to power a waterfall/feature only, but the pump must
be placed below the water level. MagFlo pumps must
be set up with a flooded suction intake and will not
suction lift.
1. Remove pump intake screen, pre-filter sponge,
and impeller screen.
2. Connect one outlet male tubing adapter (E)
to pump intake and one to pump discharge
of MagFlo Pump (A). Connect and secure your
pond tubing with a hose clamp (not included).
3. Connect pond tubing to your waterfall or water
feature.
4. Continue to Step 3.
thepondguy.com | 866-POND-HELP (766-3435)
Adjust Water Flow
Adjust water flow using the flow control valve (C), if
applicable for your installation.
5
