19
USB Copy
The USB Copy function enables you to copy files stored on USB devices such as
USB disks and digital cameras to the N5200PRO with a press of a button. To use
USB copy, follow the steps below:
1.
Plug your USB device into an available USB port on the Front Panel.
2.
In Display Mode, press the Down Button (
▼
).
3.
The LCD will display “
USB Copy?
”
4.
Press Enter (
) and the N5200PRO will start copying USB disks connected
to the front USB port.
Management Mode
During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
)
and an “Enter Password”
prompt will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is “
0000
”. If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item
Description
WAN Setting
IP address and netmask of your WAN ports.
LAN Setting
IP address and netmask of your LAN ports.
Link Agg. Setting
Select Load Balance or Failover. (N5200B PRO only)
Change Admin Passwd Change administrator’s password for LCD operation.
Reset to Default
Reset system to factory defaults.
Exit
Exit Management Mode and return to Display Mode.
Typical Setup Procedure
From the Web Administration Interface, you can begin to setup your N5200PRO
for use on your network. Setting up the N5200PRO typically follows the five steps
outlined below.
For more on how to use the Web Administration Interface, see Chapter 4:
System Management >
Web Administration Interface
.
Step 1: Network Setup
From the Web Administration Interface, you can configure the network settings of
the N5200PRO for your network. You can access the Network menu from the
menu bar.
For details on how to configure your network settings, refer to Chapter 4:
System Management >
Network Management
.
NOTE
You can also change your LCD password using the Web Administration
Interface by navigating to System > Administrator Password. For
more on the Web Administration Interface, see Chapter 4: System
Management.