09/11
31
32
With a straight edge, mark where the
seals will be trimmed.
Remove the seals and trim with a fine
toothed junior hacksaw so they are
flush with the tops of the glass panels.
Replace the seals.
33
34
Using a sharp modelling knife, trim any
excess gasket material that may have
been squeezed out when �ghtening
the brackets and hinges. Take care not
to scratch the glass surface.
Trim
Remove the magne�c seal from the
door.
Measure the width of the door and cut
the bo�om door seal to suit.
Cut into the inside wall of the bo�om
door seal (hinges end), allowing the
glass to glass seal to touch the glass
along the full length of the door. Apply
the bo�om seal.
Glass to glass
“h” Seal
Inside wall
The magne�c seals should be trimmed
around the bo�om door seals. The
notch should be 14mm tall. A�ach the
magne�c seals so they are touching the
bo�om door seal.
Underframe
Bottom
Door
Seal
14
Magnestic
Seal
Flaps only
VIEW 25
07/2019 V 2.2
