03/2021 V 1.0
VIEW 09
07/20
Remove Inline Panel Packers and feed
the Underframe Wedge Gasket into the
archway gap of the Front Inline Panel
and trace along the Glass on both
sides.
Spray water on Glass Panel and use
Nylon Block to help feed Gasket.
Mark the Wedge Gaskets at the edge of
the Inline Panel.
Remove both Wedge Gaskets and trim.
Reinstall Wedge Gaskets after
trimming.
Trim both of the Wall Profile seals at
the top face of each Wall Profile using a
blade.
Check which Stay Bar configuration
your screen has been supplied with and
refer to the relevant instructions below.
(You can find this out at the front of
these instructions).
Config A - SB1
Page 08
Config B - SB2
Page 11
Config C - SB2 X2
Page 13
Config D - SB7
Page 14
25
26
27
28