10/2021 V 1.1
VIEW 02
Cut
Cut
05/06
A�ach the Handle if included. Secure in
place with the grub screws provided.
The Handle should be oriented so that
the grub screws are not visible when
looking down on the handle.
Using a sharp modelling knife, trim any
excess gasket material from the Hinges
that may have squeezed out when
�ghtening.
Take care not to scratch the glass
surface.
Tighten all screws.
Fit all Cover Plates to the Hinges.
With a sharp modelling knife, cut the
Glass to Wall Seal tail above and below
the 90° Glass to Wall Hinges as shown.
Take care to get these cuts as close to
the hinges as possible to allow the Seal
to flex around the Hinge without
leaking.
Trim
17
18
19
20
