will be activated notifying the electronics that the latch has been opened and the gearbox will
be toggled to the “unlocked position” causing the outside knob to unlock.
Inside LED Indicators
o
The Inside LED’s indicate the current toggle state of the inner locking mechanism. The inner
locking mechanism controls if the outside knob is free to move or not. If the user presses
the inside button the LED will indicate red if the outside knob is locked from turning. The
LED will indicate green if the outside knob is free to turn.
Z-Wave Instructions
o
Adding The Doorlock to your Z-Wave network (Inclusion):
Prepare your Z-Wave controller to add a device to the network (refer to your
controller's user manual.)
Push the Z-Wave button on The Doorlock. (See diagram for button placement.)
o
Removing The Doorlock from your Z-Wave network (Exclusion):
Prepare your Z-Wave controller to remove a device from the network (refer to your
controller's user manual)
Push the Z-Wave button on The Doorlock. (See diagram for button placement.)
o
Factory Reset:
To reset The Doorlock's Z-Wave settings to their factory defaults, hold the Z-Wave
button down for 5 seconds. (See diagram for button placement.)
The Doorlock will remove its connection to your network and clear all devices from its
association group. The reset procedure should only be used when the primary
controller is missing or inoperable.
o
Association groups:
The Doorlock has one association group. Association Group 1 ("Lifeline") can
contain up to 5 devices and sends the following reports:
COMMAND_CLASS_DEVICE_RESET_LOCALLY : DEVICE_RESET_LOCALLY_NOTIFICATION
Sent on factory reset.
COMMAND_CLASS_BATTERY : BATTERY_REPORT
Sends low battery notifications.
COMMAND_CLASS_NOTIFICATION : NOTIFICATION_REPORT
Sends ACCESS CONTROL notifications when the lock state changes.
COMMAND_CLASS_DOOR_LOCK : DOOR_LOCK_OPERATION_REPORT
Sent when the lock state changes.
This product can be included and operated in any Z-Wave network with other Z-Wave certified devices
from other manufacturers and/or other applications. All non-battery operated nodes within the network will
act as repeaters regardless of vendor to increase reliability of the network.
