7
If you are not using the optional light kit with your fan,
install bottom dome by aligning threaded stem with
center hole on lower housing of fan body and rotate
clockwise until secure.
Route 2-pin connector through center hole of LED
board and carfully insert into 2-pin terminal block on
LED board. It is best to handle LED board by outer
edge in order to avoid damaging any components
on the board.
Note:
If extra wire is needed to make 2-pin
connection, carefully pull/feed the blue and white
pair of wires through the fan body. Once connected,
gently pull on the same wires from above until
board is flat against trim ring.
Position LED board flat
on surface of trim ring so
that small cut-outs in board
are positioned over holes
on trim ring. Place plastic
isolation cover over LED
board with holes properly
aligned and secure to trim
ring with three screws from
light kit screw pack.
Align slots in glass diffuser with studs on inside
edge of the trim ring. Press up and gently rotate
clockwise until snug. There is no need to forcefully
over-tighten glass diffuser.
6
WARNING
See Pages 2-3
POWER OFF
Circuit Breaker
